MATERIAL DATA SHEET

ASBESTOS FREE WOVEN

PRODUCT 9010

Description

9010 is an asbestos free composite woven from finely carded yarns containing brass wire. The 3-axis

construction and resins used provide a dense, tough material which exhibits resistance to heat and

compression under load.

Application

9010 is aptly suited for light to heavy duty service in winches, cranes, hoists etc. It is oil and grease

resistant and is suitable for light to medium duty oil immersed operation.

Technical Data

Friction Coefficient

Normal

0.566

Hot

0.565

Maximum Temperature

continuous operation

450°F

intermittent operation

550°F

Wear Rate

0.0086 in³/hp-hr

Specific Gravity

1.6 gr/cm³

Maximum Velocity

3000 ft/min

Maximum Unit Pressure

200 psi

PV Limit

1500,000 psi x ft/min

Tensile Strength

3500(0.025" thick) ASTM D638

Flexural Strength

Flexible ASTM D790

Compression Strength

600-900 psi for 5% deflection (Thickness dependent)

Shear Strength

6300 psi (0.187" thick) ASTM D732

Conductivity

1.50 BTU-in/hr/ft² /°F ASTM D2214

Specific Heat

0.25 Cal/gm/°C ASTM C351

Recommended Mating Surface

Good quality, fine grained perlite cast iron

The information and data supplied in this data sheet are believed to be accurate and reliable. Since actual

conditions of use are not within control of the Lamco Group, it is suggested that 9010 is thoroughly tested

and its suitability for use is determined before final acceptance.